Replace The Scraper; Replace The Impeller; Store The Machine; Troubleshooting - GreenWorks Pro SN60L611 Manual Del Operador

EN
8.2

REPLACE THE SCRAPER

Use only approved replacement scrapers.
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
1. Remove the screws(1) from each side plate.
2. Remove and discard the old scraper.
3. Install the new scraper.
4. Put in the mounting screw(2) and spacers and
tighten them.
8.3

REPLACE THE IMPELLER

6
5
Use only approved replacement scrapers.
1. Remove the screws(1) and side wear pad(2) of left
and right side covers.
2. Remove the nut(3).
3. Remove the belt(4).
4. Remove the the large pulley(5) with a socket wrench
(23 mm).
1
2
1
WARNING
WARNING
3
4
2
WARNING
English
5. Pull the axle(6) and remove the old impeller.
6. Install the new impeller.
7. Reinstall the components.
8.4

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the engine is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
9

TROUBLESHOOTING

Problem
The handle is
not in position.
1
14
Possible cause Solution
The bolts are not Adjust the height
engaged correct- of the handle
ly. and make sure
that the knobs
and bolts are
aligned correctly.