Replace The Impeller - GreenWorks Pro SN60L02 Manual Del Operador

9.2 REPLACE THE SCRAPER
17
9
WARNING
Use only approved replacement scrapers.
WARNING
Wear heavy gloves around the blade when you touch the
blade.
WARNING
The scraper is located at the bottom of the impeller housing.
Ensure that the battery is not installed in the tool.
1. Turn the machine to its side.
2. Remove the 5 bolts (17) below the deck that attach the
scraper (9) to the machine.
3. Remove the worn scraper (9) from the machine.
4. Install the new scraper (9).
5. Install and tighten the bolts (17) that you removed.
English
9.3 REPLACE THE BELT
18
29
Make sure to turn off the bail lever and remove the battery
pack(s) before performing any maintenance task on your
snow thrower.
1. Remove the screws (18) on the side wear pad (27).
2. Turn the large pulley (29) counterclockwise while you
remove the remaining belt (28).
3. Turn the new belt (28) onto the pulleys (29).
4. Install and tighten the screws (18) that you removed.
9.4

REPLACE THE IMPELLER

Make sure to turn off the bail lever and remove the battery
pack(s) before performing any maintenance task on your
snow thrower.
11
27
28
WARNING
10
WARNING
EN