Adjust The Chute Deflector; Led Headlights; Operation Tips; Maintenance - GreenWorks Pro SN60L611 Manual Del Operador

7.5

ADJUST THE CHUTE DEFLECTOR

You can adjust the chute deflector up and down to
change the throwing distance of the snow.
WARNING
Release the bail switch before you adjust the chute
deflector.
WARNING
Do not push the trigger so far forward that a gap
shows between the deflector and the chute.
1. Push and hold the trigger on the chute deflector.
2. Move the chute deflector(25) up to increase the
snow distance.
3. Move the chute deflector(25) down to decrease the
snow distance.
7.6

LED HEADLIGHTS

2
1
Turning the headlights on：
1. Push and hold the safety switch button(1).
2. Pull the bail switch(2) in the direction of the handle
bar to turn the headlights on.
Turning the headlights off：
3. Release the bail switch(2).
7.7

OPERATION TIPS

• If it is possible, clear the snow in the direction of the
wind.
English
• In strong winds, lower the chute delfector to direct
the snow to the ground.
• When you complete the work, let the machine
opreate for a while to prevent ice formation in the
1
discharge chute.
• If the snow is deeper than 20 cm, decrease the
speed and let the machine work at its own rhythm.
• Do not use the scraper to remove compact snow
and ice.
8
Disconnect the extension cord before maintenance.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
8.1
• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten correctly all the fasteners and caps.
• Clean the remaining snow on the machine with a
brush.
13

MAINTENANCE

WARNING
CAUTION
CAUTION
CAUTION

GENERAL MAINTENANCE

EN