Install The Upper Handle; Install The Middle Handle; Install The Chute Deflector; Install The Chute Control Rod - GreenWorks Pro SN60L611 Manual Del Operador

2. Push and hold the battery release button(3).
3. Remove the battery pack(2) from the machine.
6.4

INSTALL THE UPPER HANDLE

1. Align the holes in the middle handle and the upper
handle.
2. Insert the bolt(1) through the middle handle and
upper handle.
3. Tighten the handle knob(2) onto the bolt(1).
4. Repeat for left/right side.
6.5

INSTALL THE MIDDLE HANDLE

1. Align the holes in the middle handle and the lower
handle.
2. Put the bolts(1) through the middle handle and the
lower handle.
3. Tighten the handle knob(2) onto the bolt(1).
4. Repeat for left/right side.
English
6.6
1. Align the tabs(2) on to the slots(3) on one side first.
2. Once you have engaged one tab on one slot push
until you hear a click. Repeat on other side.
3. Push the chute deflector(1).
4. Make sure that the tabs(2) engage the slots(3) on
the two sides.
5. Make sure that the posts(4) engage the holes(5) on
the two sides.
6.7
2
1
1. Align the holes(1) in the upper chute control rod(2)
and lower chute control rod(3).
2. Put the hitch pin(4) through the holes(1).
3. Align the arrows in the discharge chute and snow
thrower deck. Make sure the discharge chute faces
forward.
4. Put the end of the chute control rod(5) straight
through the hole(6) in the bracket. Keep the grip
handle down.
5. Push the chute control rod(5) into the hole(7) behind
the deck.
6. Turn the grip handle left and right to make sure that
the discharge chute moves in the same direction.
11

INSTALL THE CHUTE DEFLECTOR

1
3
3
5
5
4
2
INSTALL THE CHUTE CONTROL
ROD
EN