How To Fill The Medication Bottle - Omron Micro Air Manual De Instrucciones

How to Fill the Medication Bottle

Have you removed Mask Adapter and the supplied Mouthpiece?
1
Remove Medication Bottle
from the Main Unit.
2
Open the Mesh Cap.
Hold the medication bottle as if covering
it with your hand.
Do not open the
bottle cap.
3
Fill Medication Bottle.
Be careful to prevent the Mesh Cap from closing
as shown in the Figure.
– The maximum capacity of Medication Bottle is 7 ml.
4
Close the mesh cap.
– Be sure to check that the Mesh Cap
is engaged. If it is not engaged,
medication will leak.
(For how to assemble the Main Unit, refer to Page 8)
Press gray tabs on
both side of Medication
Bottle at the same
time lift upwards.
Lift up the mesh
cap while pressing
your thumb hard
on the brim.
Check that the
Mesh Cap is closed.
12
5
Attach the Medication Bottle to the Main Unit.
– If the Medication Bottle is not installed
correctly, the power will not turn on.
– If the Electrodes on the Main Unit are
severely stained, the unit will not nebulize
normally. In that case, wipe off the stain.
(Refer to Page 17)
6
Attach the Mouthpiece, Mask Adapter.
7
Attach the Child's Inhalation Mask or the Mouthpiece.
•
How to install the Child's Inhalation Mask
You have
finished assembly.
How to Fill the Medication Bottle
Align both
electrodes with
each other.
You have
finished assembly.
•
How to install the Mouthpiece
You have
finished assembly.
13