Troubleshooting - Omron Micro Air Manual De Instrucciones

Nebulizador vibrador con malla
Ocultar thumbs Ver también para Micro Air:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting

If a problem occurs while you are using the unit, please check the following information before calling.
The nebulization rate is extremely low, or the unit does not nebulize at all.
Where to Inspect
Is the Battery Low Indicator turned on?
Is the Mesh dirty?
The Power Indicator does not turn on and the unit does not nebulize.
Where to Inspect
Are the polarities of batteries or rechargeable
batteries placed in the wrong direction?
Are the batteries worn?
Is the capacity of the rechargeable batteries
(NiMH) low?
Is the AC Adapter securely plugged into
the electric outlet or the connection port
of Main Unit?
Is the Medication Bottle installed to the Main
Unit correctly?
How to correct
Replace the batteries with new ones.
(Refer to Page 10)
Clean the Mesh Cap by disinfecting to remove
any stains.
(Refer to Page 18)
• If the trouble is not corrected by the above
mentioned procedure, replace the Mesh cap
with a new one.
(Refer to Page 19)
How to correct
Insert batteries or rechargeable batteries in the
correct alignment.
(Refer to Page 10)
Replace the batteries with new ones.
(Refer to Page 10)
Recharge the batteries with the commercially
available recharger or replace them
with new ones.
Insert it correctly.
(Refer to Page 11)
Install it correctly.
(Refer to Page 13)
20
The Power Indicator is illuminated, but the unit does not nebulize.
Where to Inspect
Is the Medication Bottle filled with medication?
Is the Mesh broken, stained,
or extremely soiled?
Is the medication being supplied to the
Medication Bottle?
(Is the medication in contact with the Vibrator?)
Has any medication or water collected on the
electrode of the Main Unit?
Is the electrode of the Main Unit stained?
Troubleshooting
How to correct
Fill with medication.
(Refer to Page 12)
Clean the Mesh Cap by disinfecting.
(Refer to Page 18)
• If the unit does not nebulize even after
carrying out the above-mentioned procedure,
or the Mesh is broken, replace the Mesh Cap
with a new one.
(Refer to Page 19)
Use the unit slightly slanting the Main Unit
(the side with the Button) towards yourself.
(Refer to Page 15)
Absorb the medication or water with
a soft cloth.
(Refer to Page 15)
Wipe off the stain.
(Refer to Page 17)
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ne-u22v

Tabla de contenido