Automatic Code Search For All Brands; Manual Code Search - Marmitek TV ANYWHERE REMOTE Modo De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
4. Enter the code for your brand, point the TV Anywhere Remote at your device and press
Prog+ [5] once. Continue to point the TV Anywhere remote control at your equipment until
the equipment changes Channel. (The remote control transmits an IR signal every second.
Please wait until your device reacts) When your device does react, press ENT [11] to confirm.
If you accidentally go past the code, you can stop the autosearch by pressing Prog- [5] and
by repeatedly pressing this button return to the right code. Press ENT [11] to confirm.
! If some functions of your device do not work, you need to try another code for your brand.
The search function starts after the last confirmed code.
BRAND
Philips/Radiola/Aristona/Erres
Sony/Panasonic/JVC/Sharp/Akai/Toshiba/Daewoo
Thomson/Brandt
Telefunken/Saba/Nordmende
Grundig/Blaupunkt
Nokia/ITT

3.3 Automatic code search for all brands

When searching an unknown code, you can step through the library automatically (AutoSearch).
When your device responds, you can stop the searching process and store the code you
found.
! You can dedicate any device (TV, DVD, SAT...) to the VCR, DVD, ASAT or DSAT buttons. You
first need to enter a code for the type of device you wish to control (from the code book), i.e.
if you want to program a SAT under the VCR button, enter ANY SAT code from the code book
and then follow the steps below:
1. Turn on the device you want to control.
2. Press and hold SETUP [7] until the LED indicator [2] stays lit. Release SETUP.
3. Press the mode button [3] that matches the device you wish to control. The LED [2] will flash
once.
4. Press Prog+ [5] once. After a few seconds the remote control will start stepping through
the code library (fast search, 1 code per second). When the device responds, you can press
Prog+ [5] to switch to slow search (1 code per 3 seconds). You can step back by pressing
Prog- [5] (you can step forward by pressing Prog+ [5] in case you went back too far). As
soon as the device responds again, press ENT [11] to store the code you found.
! if some functions of your device do not work, you need to try another code for your brand.
The search function starts after the last confirmed code.

3.4 Manual code search

Note: You can dedicate any device (TV, DVD, SAT...) to the VCR, CBL, DVD, CD, ASAT, DSAT or
AUX buttons. You first need to enter a code for the type of device you wish to control (from
6
CODE
1
2
3
4
5
6
© MARMITEK

Publicidad

Tabla de contenido
loading

Tabla de contenido