VDO DLD Wide Range II Instrucciones De Instalación página 47

Note: Please observe the notes from page 41 and
page 45 without fail.
1. Fix the DLD Wide Range II in the installation location. Screw
®
on the DLD Wide Range II with two screws or fi x it with dou-
®
ble-sided adhesive tape. Regularly check for intact adhesion.
2. Connect the DLD
CAN interface (see pages 47 and 48 and the fi gures on
pages 6 and 7).
• Optional: Connect the DLD
interface (see page 49).
Connecting the DLD
vehicle's electrical system
Caution: "Terminal 30" (permanent power supply) must be
tapped after the vehicle's master switch.
Caution: The DLD
match the ignition voltage.
Wide Range II to the power supply and
®
Wide Range II to the K-Line
®
Wide Range II to the
®
Wide Range II supply line voltage must
®
GB
47