VDO DLD Wide Range II Instrucciones De Instalación página 48

3. Connect "Terminal 15" (ignition voltage) to connector pin 4.
4. Connect "Terminal 31" (ground) to connector pin 1.
5. Connect "Terminal 30" to connector pin 2.
GB
See the wiring diagram on page 6.
Connecting the DLD
interface
Connect the DLD
DTCO 1381 (see page 7).
®
The fi gure on page 7 shows the connector assignment for
the data communication of the DLD
DTCO 1381 via the CAN interface and the corresponding
®
wiring diagram.
Setting the termination resistance
Delivery condition: CAN termination resistors set to ON.
The DIP switches for setting the CAN termination resistance
on the DLD
connection (see page 8).
48
Wide Range II to the CAN
®
Wide Range II to the CAN interface on the
®
Wide Range II are located above the mini USB
®
Wide Range II with the
®