Installation; Appropriate Location For Installation; Installing The Plastic Wedges - Beko GNE480E20DZXP Manual Del Usuario

3

Installation

3.1. Appropriate location for installation

Contact an Authorized Service for the installation of the
product. In order to prepare the product for use, refer the
information in the user manual and ensure that electrical
installation and water installation are appropriate. If not,
call a qualified electrician and technician to have any
necessary arrangements carried out.
WARNING:
be held liable for damages that may
B
arise from procedures carried out by
unauthorized persons.
WARNING:
B
in during installation. Otherwise, there is
the risk of death or serious injury!
WARNING:
room where the product shall be placed is
A
so tight to prevent passing of the product,
contact the authorized service.
• Place the product on a level floor surface to prevent
jolts.
• If you will use the product within a cabinet/furniture,
leave a clearance of minimum 2 cm between the side
walls and the cabinet/furniture.
• Install the product at least 30 cm away from heat
sources such as hobs, heater cores and stoves and at
least 5 cm away from electrical ovens.
• Product must not be subjected to direct sun light and
kept in humid places.
• Appropriate air ventilation must be provided around
your product in order to achieve an efficient operation.
If the product is to be placed in a recess in the wall,
pay attention to leave at least 5 cm distance with the
ceiling and the side walls.For versions which do not
have plastic wedges, make sure that a clearance of 5
cm is left from the rear wall.
•
In environments where the room temperature drops
below 10 °C, the refrigerator continues to operate to
preserve the food in the freezer. However, the fresh
food in the fridge compartment may freeze due to
the cold environment.
Manufacturer shall not
Product must not be plugged
: If the door clearance of the

3.2. Installing the plastic wedges

Plastic wedges supplied with the product are used to
create the distance for the air circulation between the
product and the rear wall.
1.
To install the wedges, remove the screws on the
product and use the screws supplied together with
the wedges.
2.
Insert the 2 plastic wedges onto the rear ventilation
cover as illustrated in the figure.
8 /31 EN
Refrigerator / User Manual