Final Checklist - Össur Miami Jr. Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

refastened after skin check (Figure 20).
COLLAR CLEANING
1. Peel the soiled, blue pads off velcro attachment. Look carefully at
the shape as you remove them so that you can reposition the clean
pads properly.
2. Wash pads with mild facial soap and water (Figure 21).
DO NOT use bleach or harsh detergents. Thoroughly rinse pads with clean
water. Wring out excess water and squeeze pads in a towel. Lay pads out flat
to air dry. It should take less than 60 minutes for them to dry.
3. Wipe white plastic collar shell clean with mild soap and water
(Figure 22).
4. Attach new pads. Fold pads in half with dull side out next to the
velcro (shiny side goes against skin); then center pad in the white
shell. Adjust the pads as needed to make sure no plastic touches
the skin (Figure 23).

FINAL CHECKLIST

A properly applied Miami Jr will look like the bottom two pictures in Figure 24.
• Collar extends from jaw to just below sternal notch.
• Chin is centered comfortably in the chin piece. Chin should not extend
over edge of Sorbatex pad, nor fall inside collar.
• Velcro straps oriented blue-on-blue, both the same length.
• Sides of the Back should overlap sides of the Front.
• Front of collar angled up toward ears. Lower plastic edge should not
be resting on patient's clavicles nor digging into the shoulder.
• No plastic touching skin. Blue Sorbatex pads extend beyond all plastic
edges.
No slack or gaps in any of the straps.
The large front/back openings are centered on the neck.
TROUBLESHOOTING:
An improperly applied Miami Jr will look like the top two pictures in
A. is too small
B. is too large
The bottom two pictures in Figure 24 show application that is just right.
(Figure 24)
.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido