After Installation; After Installing This Product - Pioneer AVIC-EVO1 Manual Del Instalacion

After installation

After installing this
product
1
Reconnect the negative (–) terminal
of the vehicle's battery.
First, double-check that all
connections are correct and that
this product is installed correctly.
Reassemble all vehicle components
that you previously removed. Then
reconnect the negative (–) cable
to the negative (–) terminal of the
battery.
2
Start the engine.
3
Press the RESET button.
Press the RESET button on this
product with a pointed object such
as the tip of a pen.
Some of the settings and recorded
contents will not be reset.
The position of the RESET button
may vary depending on the
vehicle.
4
Change the settings as desired.
For details concerning operations,
refer to Operation Manual.
5
Drive down an unobstructed road
until the GPS starts receiving the
signal normally.
NOTE
After installing this product, be sure to check
at a safe place that the vehicle is performing
normally.
13
En