General Precautions - Gewiss Chorus ANTAS GW19061 Manual De Programación

General Precautions

• Read the instructions carefully before starting installation and proceed as specified by the manufacturer;
• After removing the packaging, check the condition of the unit;
• The packaging items (plastic bags, expanded polystyrene, etc.) must not be handled by children as they may be
dangerous;
• Installation, programming, commissioning and maintenance of the product must only be performed by qualified
technicians who have been properly trained in compliance with current standards, including health and safety
regulations;
• Operate in sufficiently lighted areas that are conducive to health and use tools, utensils and equipment that are
in good working order;
• The device must be installed in accordance with the IP degree indicated in the technical features;
• The electrical system must comply with current standards in the country of installation;
• The cable wires that are not used must be isolated.
• Weld the joints and the ends of the wires to prevent malfunctions caused by wire oxidation;
• When installation is completed, always check for correct operation of the unit and the system as a whole;
• Before performing any cleaning or maintenance operation, disconnect the power supply to the device;
• In the case of device failure or malfunction, disconnect it from the power supply and do not tamper with it;
• Should the unit be in need of repair, contact only a technical support centre authorised by the manufacturer and
always use spare parts provided by Gewiss s.p.a.;
• The equipment must only be used for the purpose for which it was explicitly designed.
• Failure to follow the instructions provided above may compromise the unit's safety.
• The manufacturer declines all liability for any damage as a result of improper, incorrect or unreasonable use.
DISPOSAL
Do not litter the environment with
packaging material: make sure it
is disposed of according to the
regulations in force in the country
where the product is used.
When the equipment reaches the
end of its life cycle, avoid discard-
ing in the environment.
The equipment must be disposed
of in compliance with current reg-
ulations, recycling its component
parts wherever possible.
Components that qualify as recy-
clable waste feature the relevant
symbol and material acronym.
Programming Manual
27
IT
EN
DE
FR
ES
PT