A - Safety Instructions; Maintenance And Cleaning; Recycling - THOMSON Smart Bracket II Manual Del Usuario

COLOUR VIDEO INTERCOM
1 - INTRODUCTION
This video intercom system pairs two modules:
a receiver-monitor and an easy-to-install and
use intercom panel.
Key features:
• Colour video reception: when a visitor
touches the intercom panel call button, the
panel immediately transmits the image to
the screen and a chime indicates the visitor's
presence.
• Short-circuit protection
• Reverse polarity protection
• Automatic exposure correction: the video
camera automatically adjusts its exposure to
match the ambient light conditions.
• The LEDs integrated in the intercom panel
allow visitors to be identified without the
need for additional lighting.
• Opening the door and a control system: by
pressing buttons on the monitor, you can
control an electric lock and a dry contact for
an automatic control system (not included).
• Opening of the gate or the electric strike plate
depends on the time it takes to read the RFID
badge.
IMPORTANT: This notice should be read
carefully prior to installation. In the case of any
problems, our Hotline technicians are at your
service to provide you with any information you
may need.
WARNING: any connection error may cause
damage to the device and void the warranty.

2 - MAINTENANCE AND CLEANING

Before installing your intercom, it is important
to check the following points:
• Do not install in cases of extreme humidity,
temperatures, corrosion risk or dust.
• Do not expose to direct sunlight, rain, or high
humidity.
• Do not plug the device into a multi-socket
plug adaptor or extension cord.
• Be careful not to lose the administrator
badge (red colour) or your product will be
locked and the warranty voided.
Keep it in a safe place.

A - SAFETY INSTRUCTIONS

• Do not install near other electronic devices
such as computers, televisions or video
recorders.
• Do not install near acidic chemicals, ammonia
or sources of toxic gases.
• Do not clean with abrasive or corrosive
products. Use a damp cloth with soapy
water.
• Unplug the device if it is not being used for an
extended period of time.
• Do not plug the device into national
telecommunications installations.
• The cable between the monitor and intercom
panel must not be extended. Avoid junctions
(insulating screw joints, soldered joints, etc.)

3 - RECYCLING

This logo indicates that devices
which are no longer in use must not
be disposed of as household waste.
They are likely to contain hazardous
substances that are dangerous to
both health and the environment.
Return the equipment to your local distributor
or use the recycling collection service
provided by your local council.
www.mythomson.com
Pour en savoir plus :
www.quefairedemesdechets.fr
EN EN
7