Setting Up; Connection To The Electrical Grid - Brandy Best BCE50 Manual De Instrucciones

Setting up

The installation must be performed by a competent and qualified
installer in accordance with the regulations in force at the time of
installation.
Changes in domestic electric circuits may be needed to install this
device and must be made by competent persons. It is very dangerous
to modify or attempt to modify the characteristics of this device.
These features are visible on a label on the back your range.
Your device must be installed so as to have a space of 5cm and 7cm
behind on the sides and a gap of about 63.5 cm above the homes.
WARNING : This device must be placed on the ground.
IMPORTANT : Your device must be installed in an adequately ventilated area, in accordance with the
regulations in force at the time of installation.
WARNING : Avoid installation of the cooker near inflammable material (eg curtains, towels, etc.)
WARNING: Before connecting your device, completely unwind the power cord
The appliance should be positioned so that the plug is always accessible.
Do not pass electrical cables behind or near hot parts of the appliance and through the holes or covered parts
that could cut or damage the cables.
Make sure oven racks are properly inserted.

Connection to the electrical grid

This appliance is supplied without power cable and without the electrical plug, in consequence, you must
install a proper outlet for the operation of the stove
This device is designed to operate on 230V power grid with AC 50Hz, and requires a line protected by a 32A
fuse with a 6mm2 cable section.
Before making the connection, make sure that the power of your electrical installation is sufficiently
dimensioned to operate your equipment safely.
In case of doubt, ask your installer, the electrical connection must be performed in accordance with standards
EN60335
The section of supply cables is very important and must be sufficient to avoid overheating and create a fire
hazard in your home.
WARNING: This device must be connected to ground via a proper outlet.
Place the appliance on a stable surface,
completely horizontal
flammable objects. Allow a free flow of air
around the device.
Height adjustment and stability of the
device to the adjustable feet at the 4
corners of the stove as shown in the
diagram
and far from
21