Operating Information - Trix GG-1 22812 Instrucciones

Operating Information

• The headlights go off in a signal block.
Notes on operation with direct current
• Headlights change over with the direction of travelde-
pends on the amount of voltage present in the track.
• A filtered direct voltage is required for operation.
Operating systems with pulse duration control are
therefore unsuitable.
• Minimum voltage: 7 – 8 Volt =.
Notes on the DCC multi-train system
• Set address ex works: 03.
• Speed levels: 14 speed levels preset in DCC ope-
ration; 28 or 128 speed levels are detected and set
automatically.
• Controllable Functions:
- f0: Direction-dependent Headlights
- f1: Direction-dependent long distance headlights
- f2: Cab lighting
- f3: Sound effect: blower motor/main relay together
- f4: Low Speed Switching Range (only ABV)
- f5: Sound effect of bell (continuously ringing)
- f6: Sound Effect: Horn
- f7: Sound effect: pantograph
- f8: Sound Effect: blower motor
- f9: Sound Effect: switching relays
- f10: Sound Effect: cab radio
- f11: Sound of couplers
- f12: Sound effect: rail joints (frequency depends
not on the locomotive's speed)
• Changes in the registers are only effective for the
most part in DCC operation. For that reason you
should leave the factory settings in conventional
DC operation. Malfunctions resulting from changes
to the factory settings of the locomotive electro-
nics are caused by the operator and do not give
grounds for complaint under our guarantee or
warranty obligations.
• The installed locomotive electronics offer a wide
range of adjustment options according to the
NMRA/DCC standard. A series of parameters are
stored to this end in what are known as CVs (ab-
breviation for Configuration Variable). Please refer
to the operating instructions for your system for
the procedure for changing these setting values.
This operating system must comply with NMRA/
DCC standards if a perfect programming function
is to be guaranteed. The use of an unsuitable ope-
rating system does not give grounds for complaint
under our guarantee or warranty obligations.
• We recommend that you always change just one
setting value and see what effect this has.
• CV 8 is an important CV. Writing the value „8" will
result in the complete component being reset to the
factory settings that applied at the time of delivery!
15