Operating Information - Trix SNCB 59 Serie Manual Del Usuario

Operating Information

• The headlights and interior lights go off in a signal
block.
Notes on operation with direct current
• Travel function: Forwards – Stop – Reverse.
• Light change.
• A filtered direct voltage is required for operation.
Operating systems with pulse duration control are
therefore unsuitable.
• Minimum voltage: 7 – 8 Volt =.
Notes on the DCC multi-train system
• Set address ex works: 03.
• Driving operation: Forwards – Stop – Reverse with
load regulation.
• Speed levels: 14 speed levels preset in DCC ope-
ration; 28 or 128 speed levels are detected and set
automatically.
• Function:
– F0/light function: on/off
– F2: Turns off the acceleration and braking delay
that has been set.
– F3: Sound effect for a horn
• Malfunctions resulting from changes to the factory
settings of the locomotive electronics are caused by
the operator and do not give grounds for complaint
under our guarantee or warranty obligations.
• The installed locomotive electronics offer a wide
range of adjustment options according to the NMRA/
DCC standard. A series of parameters are stored to
6
this end in what are known as CVs (abbreviation for
Configuration Variable). Please refer to the operating
instructions for your system for the procedure for
changing these setting values. This operating system
must comply with NMRA/DCC standards if a perfect
programming function is to be guaranteed. The use
of an unsuitable operating system does not give
grounds for complaint under our guarantee or war-
ranty obligations.
• We recommend that you always change just one
setting value and see what effect this has.
• CV 8 is an important CV. Writing the value „8" will
result in the complete component being reset to the
factory settings that applied at the time of delivery!