Wall Installation - CUOGHI NEB6500 Manual Del Usuario

I
N S T A L L A T I O N

3.4 Wall installation

Fig. 7
To install the humidifier on the wall, use the bracket and the
four screws with screw anchors supplied with it. The bracket can
be used as a template to mark the holes on the wall. Respect
the distances, as indicated in paragraph 3.3, and make sure that
the bracket is level before drilling the holes. Make sure that the
wall can support the machine under operating conditions.
•
Drill four ø8 holes, 45mm deep, in the wall as shown
in Fig. 8;
•
clean out the inside of the holes;
•
insert the four screw anchors while keeping the two
expansion wings in a vertical plane;
•
fasten the bracket.
The bracket must be fitted as in Fig. 7.
Fig. 9
Once the bracket has been fixed to the wall with the four screws,
carry out the following operations, as indicated in Fig. 9:
1. Lift the machine and tilt it slightly towards the wall.
2. Move the machine until the brackets fit into place
properly.
3. Let the machine rotate, while guiding it, to the horizontal
position: at this point the brackets should be perfectly
coupled and interlocked.
4. Insert the safety screw supplied that joins the two
brackets and that prevents the machine from getting
dislodged accidentally.
- 7 -
Fig. 8
M360-4-GB