Hanging Installation - CUOGHI NEB6500 Manual Del Usuario

3.5 Hanging installation

Fig. 10
Disassemble the rear bracket A, for wall installation, as
shown in Fig. 11, by unscrewing the four screws V.
Now there five (5) screws should be available (4
screws removed from the plate A, and 1 safety
lock screw, standard supplied) each with its own
washer.
The bracket A that has just been disassembled, must be
kept for future installation.
Refit two screws into the holes F indicated in Fig. 11.
M360-4-GB
Hanging installation is done with the standard supplied brackets. Three supporting chains,
from which to hang the machine, must be prepared..
The chains must hang down as straight as possible and be attached to hooks that bear the
weight of the machine (see Tab. 2)
Use metal, possibly steel, chains, and at any rate, material that is not affected by humidity.
Respect the minimum distances indicated in Tab. 3.
Fig. 12
- 8 -
Fig. 11
Use three screws to fasten the brackets, for hanging
installation as shown in Fig. 12
The brackets are studied to allow the
removal of the filter so that normal
maintenance operations can be carried
out without having to unhook the machine
from the supporting chains.
Hook the machine to the chains and at the same time
check that it is in a horizontal position.
I
N S T A L L A T I O N