Tabla de contenido
Publicidad
29
30
1
31
32
18
2
3 mm
English
Wait 30 seconds.
Activate the faucet by placing a hand under the sensor.
Measure the temperature of the water using a thermometer. If it is too warm,
adjust the maximum temeperature.
Adjust the maximum temperature
Press the button on the function block.
Use a 3 mm Allen wrench to turn the temperature adjustment screw until the
water is the desired temperature.
3
Install the escutcheon
Measure the distance from the front of the plaster shield to one of the screw
flanges ("X").
Add ½" to this measurement.
Cut each carrier plate screw so that it is X + ½" long.
Publicidad
Tabla de contenido
