Tabla de contenido
Publicidad
1
2
3
24
ca. 10 sec
English
Change the sensor range
The faucet sensor has 5 different range settings. The faucet ships from the
factory with the sensor preset to maximum range.
If the sink is small or highly reflective, it may be necessary to reduce the sensor
range.
Remove the escutcheon from the iBox.
Disconnect the faucet plug from the function block for approximately 10
seconds.
Reconnect the plug.
The LED will blink, indicating the software version (1 blink = software version
1).
After a pause, the LED will indicate the current sensor range. For example, if it
blinks 5 times, it is set to level 5, which is the maximum range.
At this point, you have approximately 60 seconds to reset the range by
pushing the button located on function block.
Each push of the button reduces the range one level. For example, if the faucet
is set to level 5, pushing the button once will reduce it to level 4. The LED will
blink 4 times. When the LED has gone out, push the button again to reduce it
to level 3, etc. Once level 1 is reached, pressing the button again will return
the sensor to level 5.
Each time the button is pushed, the 60 second interval is restarted.
Approximately 10 seconds after the last push of the button, the sensor will
automatically calibrate itself. While the sensor calibrates, the LED will stay lit. If
further range reduction is desired, push the button again.
Approximately 60 seconds after the last push of the button, the sensor range
is locked.
Publicidad
Tabla de contenido
