Kohler K-6331 Guia De Instalacion página 4

3" (7.6 cm)
or Larger
2. Install the Supplies
CAUTION: Risk of restricted waterflow and product
damage. Use extreme care to avoid kinking and twisting the
supply hoses. The supply hoses must not be taut after
installation.
NOTE: If the sink is not installed, install it at this time. Be sure to
follow all instructions packed with the sink.
NOTE: If the sink installation requires that you coil the supply hoses
to obtain a good connection, maintain an inside coil diameter of at
least 3" (7.6 cm).
Carefully position the hot and cold water supplies so they will
not interfere with other hoses or items below the mounting
surface.
Connect and tighten the supply hoses to the supply stops. Left is
hot, right is cold.
3. Flush the Supply Lines
Place the valve outlet hose into a bucket or suitable container.
Slowly turn on the hot and cold supplies.
Slowly turn the faucet handle to the full cold position. Let the
water run briefly to remove any debris.
Slowly turn the faucet handle to the full hot position. Let the
water run briefly to remove any debris.
Turn the faucet handle to the OFF position.
1071380-2-A
Cold
Cold
Hot
4 Kohler Co.