Setup Instructions; Basic Operation - VWR SZB 100 Manual Del Usuario

Setup Instructions

1. Remove all parts from their packing materials and retain the packaging in
the event you need to transport the product.
2. Loosen the thumbscrew and install the optical body to the frame. Secure
optical body with screw.
DO NOT RELEASE THE OPTICAL BODY FORM YOUR GRASP
UNTIL IT IS FIRMLY SECURED TO THE FRAME.
3. Remove the dust caps from the eyetubes in the optical body and insert
both eyepieces into the eyepiece tube.
4. Connect the power cord or power adapter to a suitable power supply.

Basic Operation

1. Illumination Controls
Connect the power cord or power adapter to a suitable power supply. Turn
on the power switch, and adjust the transmitted light brightness control.
When turn on the reflected light brightness control, reflected light source
is switched on, the angle of halogen lamp with the reflector cup can be
adjusted.
2. Focusing Controls
Focusing adjustment is accomplished by using the focus knob located
comfortably on each side of the frame. This arrangement allows for easy,
precise adjustment without drift or discomfort. Turning either of the focus
control knobs will raise or lower the optical body.
7