Indication Of Connectors And How To Read Them - Suzuki SY413 Manual De Servicio Relacionado

INDICATION OF CONNECTORS AND HOW TO READ THEM

The connectors are indicated as shown below in "SYSTEM CIRCUIT DIAGRAM" section. For the shape and
pin arrangement of each connector used in this manual, refer to "LIST OF CONNECTORS" section. Described
below are how they are indicated and how to read them.
1. · The male terminal and female terminal are identified by a double enclosure and a single one respectively.
· The intermediate connector which connects harnesses is shown by both shapes of the male terminal and
the female terminal but the connector to be connected directly to the equipment is shown by the shape of
the connector on the harness side.
· The connectors described in this manual are always "harness side connectors" which are viewed from the
direction as shown at the right.
Male terminal
A40
4 3
8 7
Female terminal
D18
1 2 3 4
5 6 7 8
Terminal No.
2. · There are three types of connectors with respect to the way it is connected and each type is illustrated as
shown below.
· To be inserted directly into equipment
· To be connected with harness connector of equipment
· To connect between harnesses (intermediate connector)
2 1
6 5
A40
D18
Consult "LIST OF CONNECTOR" section
for the pin position refering to this code (D18-5).
Terminal No.
5
B15 1··
HOW TO USE THIS MANUAL 8A-1-9
This indicates that they are indedntical.
2