Gas Cooktop; Materials You May Need; Tools You Will Need - GE JGP321 Manual Del Propietario E Instrucciones De Instalación

Installation
Instructions
If you have questions, call 1.800.GE.CARES
In the Commonwealth of Massachusetts:
• This product must be installed by a
licensed plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be the T-handle type.
CAUTION: Before you begin—read these
instructions completely and carefully.
• IMPORTANT—Save these instructions for
local inspector's use.
• IMPORTANT—OBSERVE ALL GOVERNING
CODES AND ORDINANCES.
• Note to Installer—Be sure to leave these
instructions with the Consumer.
• Note to Consumer—Keep these instructions
for future reference.

MATERIALS YOU MAY NEED

4 screws

TOOLS YOU WILL NEED

1/8" Drill Bit &
Electric or
Hand Drill
Pipe Fittings
Adjustable Wrench
or Open End Wrench
Phillips
Head
Screwdriver

30" Gas Cooktop

or
visit our Website at:
• A flexible gas connector, when used,
must not exceed 3 feet.
• Note—This appliance must be properly
grounded.
• IMPORTANT: Leak testing of the appliance
shall be conducted according to the
manufacturer's instructions.
• Skill level—Installation of this appliance
requires basic mechanical skills.
• Proper installation is the responsibility of
the installer.
• Product failure due to improper installation
is not covered under the Warranty.
Joint Sealant
Flat-Blade Screwdriver
Ruler or
Pencil
Straightedge
12
ge.com
Shut Off
Valves
Pipe Wrench
Saber Saw