Bosch TCA 58 Serie Instrucciones De Uso página 19

en
Note: If no button is pressed within 90
seconds, the appliance switches to stand­
by mode without saving the new settings.
In this case, the previous water hardness
setting is retained.
The first time a filter is used or after
changing the filter, the appliance needs to
be cleaned.
● Fill the water tank with water.
● Place a suitable container (at least 0.5
litres) under the foaming nozzle 9.
● Turn the dial 8 to
● Allow about 0.5 litres of water to run
through.
● Turn the dial back to
Setting the temperature
It is possible to set three different coffee
temperatures.
● Switch the appliance to stand­by.
● Hold down the
4
simultaneously for at least 5 seconds.
on = Low temperature
4
+ on = Medium temperature
4 5
+ + on = High temperature
4 5 a
● Press the button to set the required
4
temperature.
● Press the button to save the setting.
a
The factory setting is the medium
i
temperature.
Energy­saving mode
The appliance can be programmed so that
it automatically switches to stand­by mode
after a certain time (from 1 to 4 hours).
● Switch the appliance to stand­by.
● Hold down the
5
5 seconds.
on = Switches off after 0.5 hours
4
+ on = Switches off after 1 hour
4 5
+ + on
4 5 a
= Switches off after 2 hours
+ + + on
4 5 a h
= Switches off after 4 hours
/ .
g h
●
.
+ buttons
5
button for at least
● Press the button to set the required
5
time.
● Press the button to save the setting.
a
The factory setting is 1 hour.
i
Reset
The settings for water hardness, tempera­
ture and energy­saving mode can be reset
to the factory settings simultaneously.
● Switch appliance to stand­by mode and
pull out trays 1 and .
● Hold down the
4
neously for at least 5 seconds. The LEDs
flash briefly to confirm the reset.
● Insert trays 1 and  again, the
appliance switches to stand­by mode.
Adjusting the grinding unit
Sliding switch 17 adjusts the degree of
grinding, from coarse to fine.
Warning
Adjust the grinding unit only while it is
running! Otherwise the appliance may be
damaged.
● Press the coffee dispensing button
● While the grinding unit is running, move
the sliding switch 17 to the desired
position: the smaller the dots, the finer the
grind.
The new setting will not become apparent
i
until the second or third cup is brewed.
Tip: For dark roast coffee beans, choose a
coarser grind; for light roast beans, select a
finer grind.
Float
The float 3 in the water tray  shows
when the tray needs emptying.
● If the float 3 is clearly visible, empty the
water tray .
and buttons simulta­
h
TCA58 06/2008
15
.
4