Husky 33139 Instrucciones De Ensamblaje, Instalación Operaciones Y Mantenimiento página 6

10. The three remaining brackets must be attached to the frame of the truck with two 1/2" wheel bolts (#11).
Drill 17/32" holes through the side of the truck frame using the two holes in each bracket as guides.
See Illustration "G".
CAUTION: Holes MUST be drilled 17/32" diameter, so that the special wheel bolts will
seat properly. If holes are too small, the bolt may break. If holes are too large, the bolt will not grip properly.
TRUCK
FRAME
Illustration "G"
11. Place the ½"wheel bolts (#11) into the frame first and then out through the brackets. Some applications will
require the use of a pull wire (#18) to align the bolts in to the drilled holes in the frame. Thread the
pull wire coil over the end of the wheel bolt and pull through frame and bracket.
See Illustration "G".
NOTE: On some applications, a spacer plate (#17) may be required on the inside of the truck frame at the
upper hole on the driver and passenger side rear brackets (#3) and (#4) before inserting the wheel bolts. See
Illustration "H" for correct location. Secure each bracket to the truck frame. The knurled portion of the bolts
will lock into the frame holes as the nuts are tightened. The use of air wrench will make installation easier.
12. Tighten all 1/2" attachment bolts to 75 ft.‐lbs. torque. Failure to tighten bolts as described may result in
fastener loss or failure.
13. Tighten each 5/8" bed rail attachment bolt to 150 ft.‐lbs. torque. Failure to tighten bolts as described may
result in fastener loss or failure. DO NOT apply torque to the nut portion of the clip nuts (#10). You will
DAMAGE it.
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information/
Tech Support. ©2018 LKQ Specialty Products Group. All Rights Reserved . July 25, 2018‐Rev3 Page‐6
18
17
11
13 12
BRACKET
TRUCK FRAME NOT SHOWN
BRACKET
TRUCK
FRAME
11
Illustration "H"