SAFETY SUMMARY (CONTINUED)
SAFETY SUMMARY (CONTINUED)
SAFETY SUMMARY (CONTINUED)
SAFETY SUMMARY (CONTINUED)
SAFETY SUMMARY (CONTINUED)
INSTALLATION WARNINGS
Always test to see that the rollator and attachments are
properly and securely locked in place BEFORE using.
OPENING/FOLDING THE ROLLATOR
(FIGURE 1)
NOTE: Refer to the FOLDING/ASSEMBLY WARNINGS in the SAFETY SUMMARY
of this manual.
OPENING
1. Swing the side frames outward until the release paddles activate
(engage upward).
2. Pull the handle DOWN and lower the seat.
NOTE: Push DOWN until the seat supports fully engage the side braces as shown
in OPEN of FIGURE 1.
3. Before using, test rollator by grabbing the side frames and, with some
force, attempt to fold them inward. The rollator will remain locked in
the OPEN position if it is engaged properly.
FOLDING
1. Raise the seat by grasping the handle and lifting UP.
2. Depress either release paddle and pivot the corresponding side frame
inward toward the front crossbrace.
3. Repeat the same procedure for the remaining side frame.
5