Other Functions; Adjusting Initial Settings; Setting The Clock; Setting The Fm Tuning Step - Pioneer DEH-P3950MP Operación Manual

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Other Functions

Adjusting initial settings

1 1
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function status.
1
Press SOURCE and hold until the unit
turns off.
2
Press SOURCE and hold again until the
clock appears in the display.
3
Press FUNCTION to select one of the in-
itial settings.
Press FUNCTION repeatedly to switch be-
tween the following settings:
Clock—FM (FM tuning step)—AM (AM tuning
step)—AUX1 (auxiliary input 1)—AUX2 (aux-
iliary input 2)—R-SP (rear output and subwoo-
fer controller)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down SOURCE until the unit turns off.

Setting the clock

Use these instructions to set the clock.
1
Press FUNCTION to select clock.
2
Press c or d to select the segment of
the clock display you wish to set.
Hour—Minute
As you select segments of the clock display
the segment selected will blink.
Black plate (21,1)
3
Press a or b to set the clock.
Pressing a will increase the selected hour or
minute. Pressing b will decrease the selected
hour or minute.

Setting the FM tuning step

The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1
Press FUNCTION to select FM.
2
Press c or d to select the FM tuning
step.
Pressing c or d will switch the FM tuning
step between 100 kHz and 50 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.

Setting the AM tuning step

The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
kHz to 1 602 kHz allowable) to 10 kHz (530 kHz
to 1 640 kHz allowable).
1
Press FUNCTION to select AM.
2
Press c or d to select the AM tuning
step.
Pressing c or d will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
<YRD5079-A/U>21
Section
07
21
En

Publicidad

Tabla de contenido
loading

Tabla de contenido