maintenance
Fill the water reservoir with tap water
2.
to the MAX line.
Set the Fabric Select Dial to LINEN.
3.
Plug the iron into a power outlet and allow
4.
the iron to heat for 2 minutes.
Turn the Fabric Select Dial to MIN
5.
and unplug the iron.
Hold the iron over a sink in a horizontal
6.
position.
WARNING: Be careful not to touch the iron's
hot surfaces.
Press the self-clean button and hold. Water will
7.
begin dripping from the steam vents. To make
sure that all of the water is removed from the
tank, slowly rock the iron side to side and front
to back for 30 seconds. When rocking the iron,
dip the nose of the iron slightly below the rear
of the iron to make certain the water circulates
completely. Release self-clean button after
one minute.
12