Chapin 82108N Manual De Instrucciones página 5

Step 1:
Attach the right Frame leg and the left Frame leg to the Frame
Body using (2) M6x55mm hex bolts and (2) M6 Nylon locknuts
per frame leg. After the frame legs have been attached, place the
two End caps onto the bottom of both frame legs. DO NOT
TIGHTEN DOWN COMPLETELY.
NOTE: Use bottom hole pattern on legs if equipped.
Step 2:
Slide bushings into the holes on
the hopper frame from outside
of the frame.
Step 3:
Insert Axle into Tire as shown and secure using (1)
M6 x 45mm Hex Bolt and (1) M6 Nylon Locknut.
Take note of hole locations on Axle, to ensure
correct orientation.
CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458
Hole at top