Brother Jumbo Manual De Instalación página 3

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
1 Outer frame
2 Inner frame
3 Right side of fabric
4 Top of inner and outer frames are even
5 Using the disc-shaped screwdriver included
in the embroidery machine package, firmly
tighten the screws.
1 Disc-shaped screwdriver
● Tightening the screws with the disc-
shaped screwdriver may be difficult
depending on the fabric thickness. If this is
the case, use your own screwdriver.
● To correctly frame the fabric in the
embroidery frame, we recommend using a
flat surface.
Attaching the embroidery
frame
After hooping the fabric in the embroidery frame,
attach the frame to the embroidery machine.
● When attaching the jumbo frame, use the
embroidery frame holder B (with light gray
corner covers.)
1 Attach the embroidery frame holder B (with
light gray corner covers) to the sewing
machine. Refer to the instruction manual of
the sewing machine, for information on how
to attach the embroidery frame holder.
1 Embroidery frame holder B (with light gray
corner covers)
Memo
Note
2 Loosen the two thumb screws on the
embroidery frame holder.
If the screw is too tight, please use the disc-
shaped screwdriver included in the sewing
machine package.
1 Left arm
2 Thumb screws
The left arm of the embroidery frame
holder can be moved.
• Only loosen the thumb screws a maximum
of 2 turns counterclockwise. Do not
remove the screw.
3 Move the left arm to align the screw on the
right side with the mark for the embroidery
frame to be installed, and then tighten the
thumb screws.
For the jumbo frame, align with mark 1.
1 Mark for jumbo frame
360 mm (H)× 360 mm (W)
(14 inches (H)× 14 inches (W))
2 Mark for border frame
100 mm (H) × 300 mm (W)
(4 inches (H) × 11-3/4 inches (W))
3 Mark for quilt frame
200 mm (H) × 200 mm (W)
(7-7/8 inches (H) × 7-7/8 inches (W))
Note
● Please firmly tighten the two thumb screws
with the disc-shaped screwdriver included
in the sewing machine package. The
machine will recognize the wrong frame
size, if the two screws are not tightened.
2/3