Prepare Installation - Best WPD38I Serie Instrucciones De Instalación

1. INSTALL DUCTWORK AND ELECTRICAL WIRING
This range hood is intended for outdoor covered patio or lanai area. As with all electric appliances, this unit must
be protected from the effects of weather.
This range hood is not designed for use with a charcoal grill.
Plan where and how the ductwork will be installed.
A straight, short duct run will allow the hood to perform most efficiently.
Install proper-sized ductwork, elbows and roof or wall cap. Connect metal ductwork to cap and
work back towards the hood location. Use 2" metal foil duct tape to seal duct joints.
Run 3-wire power supply cable to installation location.
The power cable must be a GFCI protected branch circuit.
For best capture of cooking impurities, the bottom of the hood must be located at a
distance of 36" above cooking surface.

2. PREPARE INSTALLATION

When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
Make sure that the following items are included:
- Range hood
- Wood strip (attached to back of hood)
- Installation manual
- Accessories including:
• Baffle filter with handles: 3 for 36'' width hood, 4 for 42'' and 48'' width hoods and 5 for 60'' width hood
• Shielded halogen bulbs (120 V, 50 W, MR16 with GU10 base) (2 for 36" and 42" width hoods, 3 for 48" and 60" width hoods)
• 10'' round adapter (taped inside the hood)
• Bag of parts: 3 waterproof wire connectors, 2 no. 8 x 5/8" screws, 6 no. 10 x 2" hex head screws, 4 no. 10 x 2" flat head screws,
2 wall anchors, 2 washers 3/16" ID x 3/4" OD
Included in parts bag, but not to be used (please discard): 2 wire clamps LP16-AP, 2 no. 8 x 3/8" zinc-plated screws,
8 no. 8 x 3/8" stainless steel screws, 4 stainless steel 10-32 locknuts, 4 washers 3/16'' ID x 3/4'' OD
Parts sold separately:
- ABWPD Series Backsplash, 36", 42" or 48" width (optional)
- AEWPD Series Decorative Flue, to be installed over the hood (optional)
- AWWPD Series Wall extension, 36", 42", 48" or 60" width (optional)
- Transitions, duct, elbows, dampers, wall and roof caps.
Refer to page 3 for a complete list of venting options and model numbers.
NOTE: During installation, protect countertop and/or cooktop.
CAUTION
WARNING
!
WARNING
!
! WARNING
4
R
OOF CAP
10" R
OUND DUCT
O
PTIONAL DECORATIVE
FLUE OR SOFFIT
10" R
OUND ELBOW
10" R
ADAPTER
16"
TO
18"
TOP OF WOOD
MOUNTING STRIP
36"
MINIMUM ABOVE
COOKING SURFACE
HH0181A
W
ALL CAP
OUND