Prepare Installation; Select Installation Type - Best WCN1 Serie Instrucciones De Instalación

1. PREPARE INSTALLATION

NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
Make sure that the following items are included:
- Hood
- Accessories • Decorative flue assembly (lower and upper flues)
• Hood mounting bracket
• Upper flue mounting bracket
• Aluminum grease filters
• 8" round damper
• Bag of parts including: 9 #8 x 1-1/2" Phillips flat head screws,
2 M4 x 12 Phillips round head screws,
4 M4 x 8 Phillips round head screws,
2 washers and 3 wire connectors
- Installation manual
Parts sold separately:
- Duct, elbows, wall or roof caps
- Optional baffle filters kit (set of 2) AFBWCN1
- Optional flue extension for 10'-11' ceilings model AEWCN1SS
- Non-duct kit model ANKWCN1, mandatory for non-ducted installation
NOTE: During installation, protect countertop and/or cooktop.

2. SELECT INSTALLATION TYPE

When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
2.1 N -D I
ON UCTED NSTALLATION
The ANKWCN1 non-duct kit is required for a non-ducted installation.
2.2 D I
UCTED NSTALLATION
Plan where and how the ductwork will be installed.
A straight, short duct run will allow the hood to perform most efficiently. Long duct
runs, elbows and transitions will reduce the performance of the hood. Use as few
of them as possible. Larger ducting may be required for longer duct runs.
Install wall or roof cap. Connect 8" round metal ductwork to cap and work back
towards the hood location. Use 2" metal foil duct tape to seal the joints.
2.3 A I
LL NSTALLATIONS
The minimum hood distance above cooktop is 24" . A maximum of 30" above
cooktop is recommended for best capture of cooking impurities.
Distances over 30" are at the installer and users discretion providing that ceiling
height and decorative flue length allow it.
NOTE: 10'-11' ceilings require flue extension model AEWCN1SS (stainless
steel).
(1) D
ECORATIVE FLUE
ASSEMBLY
(1) H
MOUNTING BRACKET
(1) D
HR0266A
WARNING
!
3
(1) U
MOUNTING BRACKET
(2) G
(9) #8 1-1/2'' P
X
FLAT HEAD SCREWS
(2) M4
X
ROUND HEAD SCREWS
(4) M4
X
ROUND HEAD SCREWS
OOD
(2) W
ASHERS
(3) W
IRE CONNECTORS
AMPER
R
OOF CAP
D
ECORATIVE
FLUE
H
OOD
24"
MINIMUM ABOVE
COOKING SURFACE
HH0304A
PPER FLUE
REASE FILTERS
HILLIPS
12 P
HILLIPS
8 P
HILLIPS
8" R
OUND
DUCT
W
ALL
CAP
8" R
OUND
ELBOW