Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. INSTALL DUCTWORK AND ELECTRICAL WIRING
I
NSTALLATION
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. Use 10" round ductwork.
Use metal foil duct tape to seal duct joints.
The minimum hood liner distance above cooktop must not be less than 36''.
Distances over 36" are at the installer and users discretion.
Run 3-wire power supply cable to installation location. Its length should extend at least 4 feet below the bottom of the
custom hood.
10" ROUND DUCT
10" ROUND ELBOW
36" MIN.
ABOVE
COOKING SURFACE
CPD (
DUAL INTERNAL BLOWER
T
YPICAL
2. PREPARE THE INSTALLATION
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
Make sure that the following items are included:
- Hood Liner
- Accessories:
• Baffle filters (2 for 36'' width , 3 for 48" and 60" widths)
• Shielded halogen lamps (120 V, 50 W, MR16 with GU10 base or PAR16 with GU10 base) (2 for CPDI362,
4 for all other models)
• 10" round adapter
• Bag of parts including: 12 - #8 x ½" flat head screws (16 - for CPDI602), 4 - M4 x 6 pan head screws,
1 - suction cup tool, 3 - wire nuts
Parts sold separately:
- Ducts, elbows, wall and roof caps. Refer to pages 3 and 4 for a complete list of venting options and model numbers.
NOTE: During installation, protect countertop and/or cooktop.
HOOD LINER
)
D
UCTWORK
!
VQ0010
WARNING
- 4 -
Publicidad
Tabla de contenido
