Easy Home VC9385S Manual Del Usuario página 15

NOTICE!
Risk of damage!
Using the product without the water solution tank in place or
with a wrong solution may damage the product.
− Always make sure that the water solution tank is properly
in place before using the product.
− Do not use any solvents, cleaners with strong acidic or
strong alkali formulas, or any type of cleaning solution not
specifically for use in carpet cleaning machines.
• Only use suitable (low-foaming) carpet cleaning solution.
Using incorrect solutions may cause excess foaming, which
will prevent the product from working effectively.
• Carpet cleaning solution is NOT included. Most commercially
available low foaming carpet cleaning solutions may be used.
Always read the manufacturer's instructions before use.
1. Unplug the product.
2. Lift up on the water solution tank release lever
water solution tank
3. Unscrew and then remove the water solution tank cap
solution tank.
4. Following the instructions on the bottle, add the carpet cleaning solution
and then fill the water solution tank with warm tap water (max. 104 °F / 40 °C).
Do not fill over the maximum filling line (FULL)
5. Replace the water solution tank cap.
6. Place the water solution tank back into position by pushing it down until it
clicks into place.
Repeat the steps above (except step 4) to empty the water solution
tank after use and before storage.
11 from the product (see Fig. C).
12 and then remove the
3
from the water
4
.
Operation
15