Cleaning A Carpet; Tips For Carpet Cleaning - Easy Home VC9385S Manual Del Usuario

Operation

Cleaning a carpet

• Before cleaning, determine where to start and stop, making
• Do not oversaturate the carpet with cleaning solution.
• For heavily soiled areas, additional applications may be
1. Plug the power cord
setting the on/off switch
2. Step on the handle release pedal
cleaning position (see Fig. D).
3. While pressing the solution release trigger
backwards direction towards you.
4. Release the solution release trigger and push the product forward in the
same path to remove the dirty cleaning solution from the carpet.
5. Repeat steps 3–4 to clean other parts of the carpet or heavily soiled areas.
6. When cleaning is done, turn the product off by setting the on/off switch to
the OFF position (O).
7. Push the handle forward until it is positioned upright and locked into place.
8. Unplug the product and wrap the power cord around the cord hooks

Tips for carpet cleaning

• Use the carrying handle
cleaning location.
• Do not run the product over the power cord
in your free hand while cleaning.
• Use a steady, moderate, forward and backward motion.
• Always work from back to front across a room to avoid stepping on wet
carpet.
• Do not make the carpet too wet. Use no more than two sets of forward and
backward strokes while releasing carpet cleaning solution. Always follow
with dry strokes; the more dry strokes the better.
• Wipe any cleaning solution from woodwork and furniture to prevent any
damage.
• Allow plenty of time for the carpet to dry and avoid walking on it until it is
dry.
• Increased air circulation (open doors, fans, etc.) or the use of a dehumidifier
will help the carpet dry thoroughly and prevent the growth of mold or
mildew.
• Vacuum the carpet thoroughly before cleaning it and after it has dried.
16
sure you will not walk over previously cleaned areas.
necessary.
16
into a power outlet and turn the product on by
5
to the ON position (I).
15
to lift up the product and move it to the desired
17
to lower the handle
2 , pull the product in a
16
by holding any excess cord
1
into the
14
.