Emerson IDEAL CF330BQ00 Manual Del Usuario página 8

3. Ceiling Fan Assembly
3.8
Align the Clevis Pin holes in the Downrod with the holes
in the Motor Coupler.
Install the Clevis Pin and secure with the Hairpin Clip
(Figure 8).
The Clevis Pin must go through the holes in the Motor
Coupler. It is critical that the Clevis Pin in the Motor
Coupler is properly installed and securely tightened.
Evenly retighten the two Phillips Head Set Screws to
secure the Downrod to the Motor Coupler in a vertical
position (Figure 8).
WARNING
!
It is critical that the clevis pin and set screws in the
motor coupler are properly installed and securely
tightened. Failure to verify that the pin and set screws
are properly installed could result in the fan falling.
3.9
Make sure the Grommet is properly installed in the Motor
Coupler Cover, then slide the Motor Coupler Cover on the
Downrod until it rests on the Motor Housing (Figure 9).
3.10
Place the Ceiling Cover over the Downrod (Figure 10).
Be sure that the Ceiling Cover and the Motor Coupler
Cover are both oriented correctly (Figure 10).
(Continued)
HAIRPIN
CLIP
CLEVIS
PIN
CLEVIS
PIN
Figure 8
MOTOR
HOUSING
Figure 9
Figure 10
8
MOTOR
COUPLER
HAIRPIN
CLIP
DOWNROD
GROMMET
MOTOR
COUPLER
COVER
DOWNROD
CEILING
COVER
ETL Model No.: CF330