F F R R O O N N T T P P A A N N E E L L
1
2
3
( ( 1 1 ) ) L L e e v v e e l l
Controls the 1/4" jack input level on channels 1 and 2 and the 1/4" jack input and XLR input on channel 3.
( ( 2 2 ) ) L L o o w w E E Q Q
An active tone control (shelving type: +/-15 dB) that varies the low frequency range.
C C a a u u t t i i o o n n : : Excessive low frequency boost causes greater power consumption and increases the
possibility of speaker damage.
( ( 3 3 ) ) H H i i E E Q Q
An active tone control (shelving type: ± 15 dB) that varies the hi frequency range.
( ( 4 4 ) ) M M i i d d E E Q Q
An active tone control (peak/notch type: ± 15dB) that varies the mid frequencies. (channel 3)
( ( 5 5 ) ) C C H H 4 4 / / M M o o n n i i t t o o r r L L e e v v e e l l
Controls the input level for channel 4. Controls high-impedance microphones or other high-level sources
equipped with a 1/4" phone plug.
( ( 6 6 ) ) H H e e a a d d p p h h o o n n e e L L e e v v e e l l ( ( K K B B 3 3 o o n n l l y y ) )
This sets the level to the headphone jack on the rear panel. To avoid damage to your hearing‚ make sure
to turn the dial fully counter-clockwise before using headphones. Slowly turn the knob clockwise until a
comfortable listening level is set. This does not affect the master level.
( ( 7 7 ) ) M M a a s s t t e e r r L L e e v v e e l l ( ( K K B B 3 3 o o n n l l y y ) )
This knob sets the overall level for the unit. Make sure the Master level is completely down (full counter-
clockwise) before powering up the unit. This does not affect the headphone level.
( ( 8 8 ) ) P P o o w w e e r r S S w w i i t t c c h h
This two-way rocker switch applies power to the unit when placed in the ON position.
5
6
4
5
7
8