Mounting Instructions - AEG IPK 94530 L-B FullFit Manual Del Usuario

and Mounting-instruc-
Planning-
EN
tions for the induction hob IPK
94530 L-B FullFit with PURE-
Design
PLANNING INSTRUCTIONS
Vitro ceramic glass surface
The glass size of your FullFit hob is 900 x 598
mm
Worktop requirements
The depth of your worktop must be a minimum of
600 mm.
The minimal thickness of your worktop has to be:
12 mm without an oven below the worktop
38 mm with an oven below your worktop
Wall covers
The maximum thickness for Wall covers can be
22 mm if the wall cover is mounted on the wall.
A close contact between the wall cover and the
FullFit hob has to be avoided.
Kitchen furniture front
The kitchen furniture front below the worktop
must be planned flush with the leading edge of
the worktop. A recess of the kitchen furniture
front against the leading edge of the worktop
should not been done.
Traverse for the worktop
The use of a traverse to support the worktop is
possible but the depth of the traverse cannot
be more as 25 mm from the front edge of the
cabinet.
You can find further advice for the use and the
security regulations in the user manual that is
supplied with the hob

MOUNTING INSTRUCTIONS

With the FullFit hob, you get an installation kit for
the worktop installation that includes:
a. 2x Profile for the front and the rear
of the cut out
b. 2x Profile for the left and right
hand side of the cut out
c. 2 Sett of adjustment clay with 6
bars
6
Worktop cut out
514 +1
600
45
General references
Take care that you do not get any gap between
the sealant profiles when you glue them to the
worktop. Gaps can lead to a problem in a service
case.
Installation of the sealant and the adjustment
clay
1. Mount the front and the rear sealant, to do this
you need to remove the protection foil from
the self-adhesive sealant and glue the sealant
on the clean surface on the front and rear of
the worktop cut out. Both ends must have a
45 degree cut.
2. Mount the left and right hand sealant, to do
this you need to remove the protection foil
from the self-adhesive sealant and glue the
sealant on the clean surface on the front and
rear of the worktop cut out. Both ends must
have a 45 degree cut.
3. Take care that you do not get any gap be-
tween the sealant profiles when you glue them
to the worktop. Gaps can lead to a problem in
a service case.
4. The enclosed adjustment clay can be placed
where required in the cut out and the amount
of clay can be selected due to mounting re-
quirements. The adjustment clay will support
the easy height adjustment of the hob to the
worktop surface.
Mounting of the hob
Place the hob carefully in the center of the cut out
(we recommend the use of a vacuum cab)
780 +1
max R13
904
+2
6 +1