Dustcontrol DC Tromb 400c Traducción Del Manual De Instrucciones De Servicio Original página 17

Emptying
a – Container
The container underneath the cyclone should be emptied when about 2/3 full.
c – Plastic bag
You must clean the filters before replacing the plastic bag. It should be replaced when the dust level is about 5 cm below the
discharge flap.
Dust-free bag change
The machine should be switched for the duration of the bag change. Remove the bag. The bag must be sealed as soon as it is
removed from the machine. Only use Dustcontrol's original bags.
Fit the new bag. Use the strap for dust-free work. Use the hooks for simple suspension of the bag.
Clean the filter and use the dust extractor.
L – Longopac
Close the bag using the supplied cable ties when you believe that it has been filled to a suitable level. Another cable tie is used a
little further up. This forms the bottom of the next bag. The filled bag is then cut off, and the machine is ready to be used again.
Changing the bag magazine
1. Rotate the holder to the position in which it can be pulled down.
DC Tromb, Art.nr. 9480-I 17