Festo KSK Serie Operativo Instrucción página 21

S
Place the half-shells, which you have dis-
mantled, loosely into their relevant posi-
tions with the aid of the coupling screws.
S
Push the y-axis to the hub centre.
If the slides are offset:
S
Push both slides to the same axis position.
In this way you can compensate for any possible distortion.
S
Tighten the coupling screws of the divided hub.
Make sure they are symmetrically clamped to an equal degree.
6 Commissioning
Note
Fast rotating shafts contain high energy.
S Make sure that nobody can touch the rotating KSK-... and that no objects can
brush against it (by providing e.g. a protective screen or covers).
Otherwise this could lead to serious injury in the form of burns.
S
Make sure that the documentation concerning the planning of your multi-axis
system is available.
The rotational speeds, slide speeds, fitting tolerances and slide offset must
not exceed the maximum permitted values for your constellation (see also the
chapter Characteristic curves).
S
Start a test run at low speed.
Festo KSK-... 0010NH English
Fig. 16 M
s
21