Programming Telephones - Fermax ADS Manual De Introducción

Main Menu - Programming Telephones
This menu lets you enable programing of ADS telephones/monitors from the ADS
Guard Unit.
To access "Telephone Prog" from the main menu:
Menu prog.
1-Prog. ON
2-Prog. OFF
B-Salir
1. Press"4"
The Telephone Prog menu has two options:
Prog. Menu
1- Prog. ON
2- Prog. OFF
B- Exit
Prog. ON: Enables programming of ADS telephones/monitors
from the ADS Guard Unit.
1º- Press key "1" to enable programming.
If programming telephones/monitors from the Guard
Unit is allowed, a telephone symbol
the left part of the display.
The panels are disabled (they cannot be called) and
the Guard Unit waits for the telephones to be
programmed.
If the equipment is reset, programming mode is
disabled.
2º - Exit the programming menu and the main menu
(press the "B" key twice).
3º- Set the telephone/monitor in programming mode.
(there will be audio communication with the same).
4º- Use the Guard Unit keypad to introduce the house
nº to be allocated (from 1 to 199) and press the "C"
or "Bell" key.
5º- Take the telephone/monitor out of programming mode.
Repeat steps 3 to 5 until all the telephones/monitors in the
installation are programmed. Disable the Prog. ON option.
Prog. OFF: Programming ADS telephones/monitors ADS
from the ADS Guard Unit is not allowed.
Press key "2" to disable programming.
Press "B" to exit.
Prog. Menu
1- Prog. ON
2- Prog. OFF
B- Exit
appears on
Pag 25