Programming The Monitor - Fermax MICROLINE Manual De Instrucciones

KIT
VIDEOMICRO 5 HILOS
VIDEOMICRO 5 HILOS

PROGRAMMING THE MONITOR

Once the monitor has been connected, carry out the following steps in order to program it:
1. Put the J1 switch to the
PRG position.
confirmation sound
will be heard.
The time between steps 1 and 2 must be less than 2 minutes. If this time is exceeded,
return the switch to its original position and start the sequence again.
VERY IMPORTANT NOTE
The monitor will not function until it has been programmed.
Page 8
J1
PRG
2. Press the call button. A
A confirmation sound is
again emitted.
H I G H I G
H R H R
E S O E S O
C C C C
D C D C
L U T L U T
A M A M
I O N I O N
E R A E R A
P A N
& T
IL T
3. Return the switch to its
original position and
place the Monitor in
position.
J1
PRG