Assembly Of The Rear Drawbar; Assembly Of The Handlebars; Assembly Of The Levers - EMAK MZ2065 Manual De Instrucciones

ASSEMBLY OF THE REAR DRAWBAR

(Fig. 4)
- Position drawbar 3 in correspondence
with the central hole, then lock it with
the screw and the self-locking nut. The
drawbar can be adjusted in height.
- Unloosen screw 4, adjust and screw
back on (Fig. 4).

ASSEMBLY OF THE HANDLEBARS

Fig. 4
(Figs 5/A-5/B)
Fit handlebar 1 onto the Motorhoe by me-
ans of the relative screws and washers
as shown in Fig. 5/a.
The handlebar may be adjusted in
height in three positions by unscrewing
lock knob 2 and positioning the screw
in another hole after having turned the
handlebar. Thereafter lock the knob.
On request, the handlebars can be adju-
sted both in height and sideways with the
Fig. 5/A
possibility of locking them in the wanted
position.
For those models having such an
adjustment, this operation must be car-
ried forth with lever 3 (Fig. 5/b).
Make sure that lever 3 is always locked
after adjustment.

ASSEMBLY OF THE LEVERS

Fig. 5/B
(Fig. 5/C)
The forward and reverse throttle cables
(if applicable) are already connected to
the frame and fitted in their correspon-
dent levers.
Fit the levers in their respective seats on
the handlebars.
How to change the drive
(forward-reverse):
Fig. 5/C
- Pull control lever 4: forward gear
- Pull control lever 5: reverse gear (Fig.
5/C).
21