Philips Norelco 7110X Manual De Instrucciones página 9

ENGLISH
16 16
C
Open Razor Head assembly again and
6
leave open to air dry.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue.This could damage the
shaving heads.
C
If the shaving unit becomes detached from
7
the razor, you can easily reattach it.
You may also clean the hair chamber
8
without water by using the supplied
Once A Month: Razor Heads
Do not mix up the cutters and combs as the
shaving performance may be adversely affected for
several weeks before optimal shaving performance
is restored.
Turn razor OFF, remove the charging plug
1
from the outlet and cord from the razor.
C
Press the razor head release button to
2
open the razor head assembly.
C
Turn the wheel counterclockwise (1) and
3
remove the retaining frame (2).
C
C
brush.
C
C
ENGLISH
Remove and clean one set of cutters and
4
combs at a time.
Separate the cutter from the comb and
5
rinse clean under hot water.
Do not clean more than one cutter and comb at a
time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
Replace the set back into the Razor Head
6
Assembly so that the "wings" on the comb
fit within the brackets located towards the
center of the Assembly.
The set will only fit into the Razor Head Assembly
if the 'wings' are between the brackets. Make sure
that the two pointy edges of the head fit exactly
into the recesses.
Repeat the process for the other two sets
7
of cutters and combs.
Replace the frame.
8
Press down (1) and turn wheel clockwise
9
(2) until it locks into place.
Close the Razor Head Assembly.
10
17