Removing Restraint Belt From Stroller - Britax BOB SINGLE Instrucciones

1. While holding down Red Release
Buttons on both Accessory Adapters
at sides of stroller, pull ICSA forward
and out of Receiver Sockets, keeping
alignment even, left to right, as you pull.
2. Slide Covers UP
Push to slide each Cover (at front of
stroller Accessory Adapters) up on
each side of stroller, covering each
Receiver Socket.
REMOVING RESTRAINT BELT
FROM STROLLER
Restraint Belt is intended
for use with combination of
BOB Infant Car Seat Adapter
and compatible Infant Car
Seats only. The Restraint Belt
must be removed prior to
using stroller without Infant
Car Seat. Failure to remove
Restraint Belt when not in
use may result in accident,
injury or death.
1. Unscrew Captured Screws
Using a screwdriver, unscrew each
Captured Screw from each respective
stroller Anchor Nut.
2. Keep Restraint Belt
Keep restraint belt together with
ICSA for next use.
16
P637100A