Infant Car Seat Installation; Cs1305 Britax/Bob Infant Car Seat Installation (All Models With Click & Go) - Britax BOB SINGLE Instrucciones

INFANT CAR SEAT
INSTALLATION
CS1305 BRITAX /BOB INFANT CAR
SEAT INSTALLATION (ALL MODELS)
Failure to properly secure
Restraint Belt and to properly
install Infant Car Seat on Infant
Car Seat Adapter may result
in accident, injury or death.
1. Prepare Stroller
Set parking brake, rotate canopy
towards handlebar, place Restraint Belt
ends to the sides of stroller seat (see
stroller owner's manual if necessary)
2. Align Infant Car Seat
Place Infant Car Seat"rear facing",
directly centered on top of ICSA, align
ICS Adapters on Infant Car Seat with
the Click & Go Receivers on ICSA.
3. Verify Infant Car Seat is Latched
Properly
Push Infant Car Seat straight down
onto ICSA until the adapters on each
side lock into the receivers on ICSA.
CLICK
4. Verify Infant Car Seat is Securely
Attached
Lift up to ensure the Infant Car Seat
is secure.
5. Secure Restraint Belt
Proceed to section titled "Securing
Restraint Belt" (pg.14).
CLICK
12
P637100A