Stanley POP Avdel ProSert XTN20 Manual De Instrucciones página 7

10. DO NOT operate tool with the nose housing removed.
11. Adopt a fi rm footing or a stable position before operating the tool.
12. Prior to use, inspect airlines for damage, all connections must be secure. Do not drop heavy objects on hoses.
A sharp impact may cause internal damage and lead to premature hose failure.
13. Do not lift the placing tool by the hose. Always use the placing tool handle.
14. Vent holes must not become blocked or covered.
15. Disconnect the air hose from the tool before performing any maintenance, attempting to adjust, fi t
or remove a nose assembly.
16. Keep tool handles dry, clean, and free from oil and grease.
17. When carrying the tool from place to place keep hands away from the trigger to avoid inadvertent activation.
18. Never leave operating tool unattended. Disconnect air hose when tool is not in use.
19. Adequate clearance is required for the tool operators hands before proceeding.
20. Do not abuse the tool by dropping or using it as a hammer.
21. Keep dirt and foreign matter out of the hydraulic system of the tool as this will cause the tool to malfunction.
is one of continuous product development and improvement
STANLEY Engineered Fastening policy
and we reserve the right to change the specifi cation
of any product without prior notice.
E N G L I S H
7