Keeper KX9.5 Manual De Instrucciones página 9

Pendant Operation
The handheld pendant switch activates a solenoid
that activates power to the winch motor.
To connect the handheld pendant switch, remove
the cover on the plug receptacle and insert the plug
end of remote switch (See Figure 10). The plug on
the pendant control cord is keyed and will fit into the
socket only one way.
The switch trigger returns to the "Off" position when
released. To change direction, move the toggle in the
other direction. (See Figure 10).
The red push button activates the LED work light.
! !
CAUTION
The switch assembly must be kept free of dirt and
moisture to ensure safe operation.
Wireless Operation (Remote KTA14126)
Your winch has an internal Wireless Remote Module that is activated by depressing the switch located on the
side of the top cover to the "up" position. Your Wireless Module is now active and ready for use. To activate
your Wireless Remote Fob, place the switch on your winch to the "On" position. Then depress both buttons
on the Fob at the same time and hold for 3-5 seconds, you will see the indicator light come on. Your Wireless
Remote is now active and ready for use. Please note that the unit is programmed for a 1 second delay in both
starting and stopping.
This may represent a 6" to 8" travel in the rope.
Your wireless remote is now ready. Enjoy your wireless remote switch winching experience.
The
FIGURE 10
Indicator
Light
Key
Wire
Slot
Rope
IN
IN
OUT
Key
Slot
FIGURE 11
Wire
Rope
OUT
ON
OFF
9